Varytec Retro Blinder 80 LED, User Manual

Page: 20 / 40

7 Operating
7.1 Starting the device
To start operation, connect the device to the mains. The device is immediately operational.
The set values are retained during a power supply interruption.
7.2 Operating modes
This setting is only relevant when the device is controlled via DMX.
n Press [MENU] repeatedly until the display shows ‘Address’ . Confirm with [ENTER] .
Use [UP] and [DOWN] to set the desired DMX address in a range from ‘001’ … ‘512’ and
confirm with [ENTER] .
n
Press [MENU] repeatedly until the display shows ‘CH Mode’ . Confirm with [ENTER] .
Use [UP] and [DOWN] to select a DMX mode ( ‘05CH’ , ‘08CH’ or ‘21CH’ ) and confirm with
[ENTER] .
n
Press [MENU] repeatedly until the display shows ‘Mode’ . Confirm with [ENTER] .
Use [UP] or [DOWN] to select the menu item ‘DMX’ and confirm with [ENTER] to enable the
DMX mode.
Make sure that the DMX address number matches the configuration of your DMX controller.
The following table shows the highest possible DMX address for the various DMX modes.
Operating mode ‘DMX’
Operating
20
Retro Blinder 80 LED
Blinder