Troubleshooting
Before calling service personnel, please check the following chart for a possible cause to the trouble you are experiencing.
Perform the adjustments according to page 13 “Operation The Monitor”
If the problem you have experienced isn’t described below or you can’t correct the problem, stop using the monitor and
call service personnel or your dealer.
Problem
Check these things
No Display
Ensure the power plug is installed correctly on both ends.
Check the main power switch is set to “—“
Check that source equipment is operating correctly.
Check the input signal is compatible with this display.
The image is not centered
Check the input signal is compatible with this display.
The image is not locked correctly
Check the input signal is compatible with this display.
The remote control doesn’t work
Make sure the batteries fresh and are installed correctly.
Ensure the remote is aimed at the IR sensor on the front of the display
The picture color looks poor
Check the picture settings.
Reset the display.
If you are using YUV terminals, make sure cables are correctly connected.
Compliance
FCC Compliance Statement:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference at their own
expense.
Warning
This is class A products. In a domestic environment this product may
Cause radio interference in which case the user may be required to take adequate measures.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions : (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
CE
EN 55022
、
EN 61000-3-2
、
EN-61000-3-3
EN 55024
、
IEC61000-4
EN 60950 [Low-Voltage Directive (73/23/EEC)]
VT550 Series
39
www.vartechsystems.com
