POWXG4038
EN
Copyright © 2019 VARO
P a g e
|
6
www.varo.com
5.5
Service
▪
Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 MACHINE-SPECIFIC SAFETY WARNINGS
▪
Always direct the cable to the rear, away from the appliance.
▪
If a cord becomes damaged during use, disconnect the supply cord from the mains
immediately.
▪
Operate the appliance only in daylight or in good artificial light.
▪
Walk, never run.
▪
Keep all cooling air inlets clear.
▪
Do not attempt to modify the power tool in any way. The use of any attachment or
accessory over than those recommended in this instruction manual could result in
damage to the power tool and injury to the operator.
▪
Never feed hard objects such as stones, bottles, cans or pieces of metal into the Vac-
Blower. They can cause damage to the machine and possibly injury to the operator and
bystanders.
▪
If a foreign body, or other debris, is accidentally feed into the Vac-Blower, stop it
immediately and do not use the Vac-Blower until it has been checked and you are sure
that the entire Vac-Blower is in a safe operating condition.
▪
If the Vac-Blower makes any unusual noise or starts to vibrate abnormally STOP
immediately remove the plug from the mains supply and investigate the cause. Excessive
vibration can cause damage to the Vac-Blower and injury to the operator.
▪
Never operate the appliance while people, especially children, or pets are nearby
▪
The operator or user is responsible for accidents or hazards occurring to otherpeople or
their property.
▪
Before using ,always check the appliance including supply and extension cord for signs
of damage and aging
▪
Never operate the appliance with defective guards or shields, or without safety devices,
for example debris collector in place
7 BEFORE USE
Steps prior to operation
Only operate the device after completely assembling it. Prior to each use, check the power
cord for signs of damage. Under no circumstances should the power cord be used if it shows
any signs of damage.
8 ASSEMBLY
The Vac-blower must not be used or switched on until it has been fully
assembled.
8.1
Assembling the tubes, wheels and adjustable handle(Fig. 1, 2, 3)
Insert the intermediate suction/blower tube (Fig. 1) into the Vacuum-Blower body ensuring that
it is fitted correctly and pushed fully home and secure with the two screws provided. Fit the
wheeled suction-blower tube into the intermediate suction-blower tube (Fig. 2). Ensuring that it
is fitted correctly and pushed fully home.
Get the wheel screw through the front small hole, tighten the wheel nut until the wheels are
fully installed.
Insert the auxiliary handle into the blower body (adjust the handle to suitable position, tighten
the know screw until the handle is fully locked)
