POWX0477
EN
Copyright © 2021 VARO
P a g e
|
9
www.varo.com
9.2
Triangular sanding head (Fig. 9)
The triangular sanding head does not rotate, but vibrates.
As the triangular sanding head can revolve on bearings, it can sand right into the corners of
the wall / ceiling.
In the corners reduce the contact pressure, otherwise there will be excessive load on the tips
of the triangular sanding disc.
Heavily worn corners of the triangular sanding head can easily be replaced
NOTE: Ensure that the sandpaper (7) you are using is suited to the task,
Overly coarse grit paper may remove material too quickly to control. While
overly fine grit paper may clog too often and not shape down the surface.
CAUTION: Take care to avoid sharp projections and nails, etc. This will wipe
out the sandpaper and probably damage the sponge pad as well.
10 CLEANING AND MAINTENANCE
10.1
Keep tool clean
Periodically blow out all air passages with dry compressed air. All plastic parts should be
cleaned with a soft damp cloth. NEVER use solvents to clean plastic pats. They could possibly
dissolve or otherwise damage the material.
Wear safety glasses while using compressed air.
Clean the vacuum swivel connector as too much dust will keep it from turning freely.
11 TECHNICAL DETAILS
Rated power
710 W
Rated frequency
50 Hz
Rated voltage
230-240 V
Rotation speed
ʘ
600-1500 min
-1
Rotation speed
Δ
3000-6000 min
-1
Disc diameter
215 mm
Round sanding motion
Rotation
Triangular sanding motion
Vibration
Sanding surface triangular pad
285x285x285 mm
Cable length
4 m
Vacuum cleaner hose
4 m
Carbon brush motor
Yes
Lock-on button
Yes
Oscillations width
1.5 mm
Sanding diameter
225 mm
Length without extension tube
110 cm
Length with extension tube
110-165 cm
Electronic speed control
Yes
soft grip
Yes
vibration reduction
Yes
Hook & loop system
yes
Base material
Aluminium
