POWESET2
EN
Copyright © 2018 VARO
P a g e
|
6
www.varo.com
▪
When grinding discs have to be mounted on the thread of the spindle, make sure that the
spindle has sufficient thread. Make sure that the spindle is sufficiently protected and does
not touch the grinding surface.
▪
Before use, inspect the grinding disc for any damage. Do not use grinding discs which are
cracked, ripped or otherwise damaged.
▪
Before use, let the machine run idle for 30 seconds.
▪
Immediately switch off the machine in case of abnormal vibrations or occurrence of
another defect. Carefully inspect the machine and grinding disc before switching the
machine on again.
▪
Make sure that sparks do not put people into danger or that they contact highly flammable
substances.
▪
Make sure that the workpiece is sufficiently supported or clamped. Keep your hands away
from the surface to be cut.
▪
Always wear safety goggles and hearing protection. If desired or required also use another
kind of protection like for example an apron or helmet.
▪
Ensure that mounted wheels and points are fitted in accordance with the manufacturer’s
instructions.
▪
Ensure that blotters are used when they are provided with the bonded abrasive product
and when they are required.
▪
If a guard is supplied with the tool never use the tool without such a guard.
▪
For tools intended to be fitted with threaded hole wheel, ensure that the thread in the
wheel is long enough to accept the spindle length.
▪
Ensure that ventilation openings are kept clear when working in dusty conditions. If it
should become necessary to clear dust, first disconnect the tool from the mains supply
(use non-metallic objects) and avoid damaging internal parts.
▪
Though poor conditions of the electrical mains, shortly voltage drops can appear when
starting the equipment. This can influence other equipment (eq. blinking of a lamp). If the
mains-impedance Zmax <0.348 Ohm, such disturbances are not expected. (In case of
need, you may contact your local supply authority for further information.
7 OPERATION
7.1
Fitting the auxiliary handle
Ensure that the plug is not in the socket when fitting or removing the
auxiliary handle.
The side handle can be used for both left-hand and right hand control.
▪
Fasten the side handle for left-hand operation on the right-hand side of the machine.
▪
Fasten the side handle for right-hand operation on the left-hand side of the machine.
7.2
Assembly the protective guard (Fig. 2 & 3)
1. Loosen the clip of the protective guard (8) by pulling lock lever of protective guard (1)
outward.
2. Turn the protective guard so that uncovered part of the disc is as far apart as possible from
the hand on main handle (4).
3. Fix the protection guard by pushing the lock lever
inwards
(the protective guard should no
longer be able to move).
NOTE:
If the protective guard cannot be fixed firmly by the lock lever (1), use a hexagon
wrench to tighten the hexagon nut. (See attached figure 3)
7.3
Replacing the grinding disc (Fig. 4 & 5)
Beware
– a disc which has been used may be very hot!
