POWEG6015
EN
Copyright © 2017 VARO
P a g e
|
6
www.varo.com
7.2
Use of the cable holder (See fig 3)
The handle is equipped with a cable holder that serves for connection of the extension cable.
In order to reduce strain on the cable inlet, form a loop and locate the cable around the strain
relief hook.
8 OPERATION
The electric grass trimmer is designed only to cut grass.
The electric grass trimmer has a fully automatic line extension system. If the line of the electric
grass trimmer is reduced through operation, it is automatically extended to the maximum
cutting width. This ensures that you can cut your lawn with the perfect cutting width at all times.
If the line is too long when you use the equipment for the first time, the
surplus end of it will be cut by the blade on the guard hood.
Your grass trimmer will work at its best if you observe the following instructions:
Never use the grass trimmer without its safety devices.
Do not cut grass when it is wet. The best results are had on dry grass.
Connect the power cable to the extension cable and fasten this to the strain-relief clamp.
To switch on your grass trimmer, press the ON/OFF switch.
To deactivate the grass trimmer, let go of the On/Off switch.
Do not move the grass trimmer against the grass until the switch is pressed, i.e. wait until
the trimmer is running.
For the correct cutting action, swing the grass trimmer to the side as you walk forward,
holding it at an angle of approx. 30° as you do so.
Make several passes to cut long grass shorter step by step from the top.
Use the edge guide and the guard hood to prevent unnecessary wear on the line.
Keep the grass trimmer away from hard objects in order to avoid unnecessary line wear.
8.1
Switching on and off
To switch the appliance on, press the on/off switch.
To switch the appliance off, release the on/off switch.
CAUTION! After switching off, the nylon line will continue to rotate for a few
more seconds.
8.2
Replacement of the spool and line
Unplug from the socket.
Press the sides of the spool cover and remove the cover
Remove the empty line spool.
Thread the ends of the line on the new line spool through the eyelets in the spool
receptacle.
Fit the spool cover back in the spool holder.
When you start the equipment again the line will be cut to the perfect length automatically.
CAUTION! Under no circumstances wind extra line on the empty spool but
instead replace it with a new one, the same as the original. The use of line
with different characteristics to those of the original can permanently
damage the grass trimmer as well as annulling the terms of the guarantee.
