POWE10025
EN
Copyright © 2017 VARO
P a g e
|
5
www.varo.com
Always use ear-protection, when machine is in use!
Recommended nominal operating-time: approx. 20 minutes under
permanent load.
Rest after permanent operation: approx. 5-10 minutes.
7 OPERATION
WARNING: Prior to assembly and adjustment always pull out the power
plug from the mains socket.
7.1
Changing drill or screwdriver bit
Insert the chuck key in one of the three holes on the side of the chuck (1), turn to open.
Insert the desired drill or screwdriver bit in the chuck and turn the chuck key the opposite
way until the chuck has a firm grip on the drill or screwdriver bit.
Check that the drill or screwdriver bit is in the centre of the chuck and is secure.
7.2
Switching on/off (Fig. 1)
Connect the plug to the power supply. The power-on indicator (9) is illumed until the tool
disconnect from the power mains.
To start the tool by squeezing the ON/OFF switch (4).
Release the ON/OFF switch to stop the tool.
If you press the lock-on button (6) while the ON/OFF switch is depressed, the ON/OFF
switch is kept in the operating position.
To release the ON/OFF switch (4) and turn the tool off.
7.3
Forward/reverse lever (Fig. 2)
The forward/reverse lever (3) is to determine the rotation direction of the chuck.
To select forward rotation, release the ON/OFF switch (4) and push the forward/reverse
lever to right (R) side of the tool. To select reverse rotation, push the lever to left (L) side
of the tool.
NOTE: When changing the position of the lever, be sure the ON/OFF switch
is released and the motor is stationary.
7.4
Variable speed (Fig. 3)
This tool has a speed control dial (5) that delivers higher speed by turning to the
“
+
” direction,
and delivers lower speed by turning to
“
-
”direction.
