POWDP3515
EN
Copyright © 2020 VARO
P a g e
|
8
www.varo.com
8.3
Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (12). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged
2 LED’s are litt: Battery 60% charged
1 LED is litt: Battery almost discharged
9 ASSEMBLY
9.1
Fitting the auxiliary handle (Fig. 4)
Warning: Prior to assembly and adjustment always switch off the grinder
and pull out the battery pack from the angle grinder body.
The auxiliary handle (6) can be attached to the angle grinder in 2 different positions: left and
right.
9.2
Assembly the protective guard (Fig. 5-6)
▪
Loosen the clip of the protective guard (7) by pulling lock lever of protective guard (1)
outward.
▪
Turn the protective guard so that uncovered part of the disc is as far apart as possible
from the hand on main handle (3).
▪
Fix the protection guard by pushing the lock lever inwards (the protective guard should no
longer be able to move).
NOTE: If the protective guard can not be fixed firmly by the lock lever (1),
use a hexagon wrench to tighten the hexagon nut.
Note: the protective guard must be positioned to protect the user if the disc
shatters during use.
9.3
Replacing the grinding disc (Fig. 7
– 8)
Beware
– a disc which has been used may be very hot!
Warning: prior to assembly and adjustment always pull out the battery pack
from te grinder body.
▪
Depress and hold down the spindle lock button (2) to secure the spindle.
▪
Turn the output spindle until it locks.
▪
Remove the outer flange and backing flange by using the two-hole spanner provided.
▪
Fit the desired disc (8) on the spindle and replace the outer flange and backing flange.
Release the spindle lock.
Important! Only ever press the spindle lock when the motor and grinding
spindle are at a standstill!
You must keep the spindle lock pressed while you change the wheel!
