POWC20100
EN
Copyright © 2021 VARO
P a g e
|
5
www.varo.com
▪
Saw blades must be kept sharp and in good condition. Replace partially fractured and
broken saw blades immediately.
▪
Work calmly and evenly with the jig saw. You will thus avoid accidents and the saw blades
and the jig saw will last longer.
7
OPERATING INSTRUCTIONS
7.1
Changing the saw blade (Fig 1)
Releasing the saw blade.
Turn the screws anticlockwise (A)
Insert the saw blade in the ram up to the stop and tighten the two screws of the retention clip.
Important ! : Make sure the saw blade sits properly in the slot of the roller and ram.
7.2
Switching ON/OFF (Fig 2)
Switching ON : Press the On/Off switch.
Continuous operation. Lock the On/Off switch with the locking button.
Switching Off : Press the On/Off switch and release.
A: locking button
B: ON/Off switch
7.3
Adjusting the base (fig 3)
Loosen the 2 screws to set the base to an angle up to 45° on the right or left side and re-tighten
the screws.
7.4
Dust extraction
The jigsaw is equipped with a dust extractor socket. You can connect your vacuum cleaner to
the socket at the rear of the jigsaw. If you require a special adapter, please contact the
manufacturer of your vacuum cleaner.
8
TECHNICAL DATA
Nominal voltage
230-240 V - 50 Hz
Power consumption
350W
Cutting rate
3000 min
-1
Cutting depth in wood
45 mm
Cutting depth in steel
6 mm
Cutting depth in plastic
10 mm
Mitre cuts
Up to 45° (left and right)
Connection type
Universal
9 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
86 dB(A)
Acoustic power level LwA
97 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration)
17.9m/s²
K = 1.5 m/s²
