POW63771
EN
Copyright © 2016 VARO
P a g e
|
9
www.varo.com
7.5
Retrofitting for mulching mower
Warning: only with a stopped motor and standstill cutter
Raise the rear cover and remove the grass bag. (Fig. 5a)
Push the mulching wedge into the deck. Lock the mulching wedge with the button into the
opening on the deck. (Fig. 5b)
Lower the rear cover.
8
OPERATION
8.1
Before starting
Service the engine with gasoline and oil.
Warning! Petrol is highly flammable
Store fuel in containers specifically designed for this purpose.
Refuel outdoors only, before starting the engine and do not smoke while refueling or
handling fuel.
Never remover the cap of the fuel tank or add petrol while the engine is running or when
the engine is hot.
If petrol is spilled, do not attempt to start the engine but move the machine away from the
area of spillage and avoid creating any source of ignition until petrol vapors have
dissipated.
Replace all fuel tanks and container caps securely.
Before tipping the lawn mower to maintain the blade or drain oil, remove fuel from tank.
WARNING: never fill fuel tank indoors, with engine running or until the
engine has been allowed to cool for at least 15 minutes after running.
8.2
To start engine and engage blade
The unit is equipped with a rubber boot over the end of the spark plug, make certain the
metal loop on the end of the spark plug wire (inside the rubber boot) is fastened securely
over the metal tip on the spark plug.
Press the primer bulb 3-5 times before starting the engine. (Fig. 6a)
Standing behind the unit, grasp the brake control handle and hold it against the upper
handle as shown in Fig. 6b.
Grasp the starter handle as shown Fig. 6b and pull up rapidly. Return it slowly to the rope
guide bolt after engine starts. Release the brake control handle to stop the engine and
blade.
Start the engine carefully according to instructions and with feet well away
from the blade.
Do not tilt the lawn mower when starting the engine. Start the mower on a
level surface.
Keep hands and feet away from the rotating parts. Do not start the engine
when standing in front of the discharge opening.
