POWXG2015
EN
Copyright © 2014 VARO
P a g e
|
9
www.varo.com
8.3
Angle change of rear handle
To permit vertical operation of the unit, the angle of the rear handle can be changed. To
reduce fatigue when trimming hedges, the handle can be swivelled 90° to the left or to the
right.
8.3.1
How to change the angle
Push back the throttle lever, and rotate the rear
handle, pulling the rotation locking pin.
Rotate the rear handle 90 degrees to the right or
to the left.
After completing the rotation, release the locking
pin. To secure the rear handle, hold the rotation
locking pin gently with one finger.
Use only as much throttle as is needed to do the job. Excessive engine speed is
unnecessary.
Tilting the trimmer 5 to 10° towards the object to be cut will make things easier and
produce good results.
Always keep to the carburettor side of your trimmer, and never to the silencer side.
During the first few minutes when a new machine is first used, grease may come out of
the gearbox. Since this is excess grease, it is not a cause for alarm. Just wipe it off when
the engine is switched off.
8.3.2
Vertical operation
When rotating the rear handle to the
right, hold the rear handle with your
right hand, and the front handle with
your left hand..
When rotating the rear handle to the
left, hold the front handle with your
right hand, and the rear handle with
your left hand. Cut using a circular
movement.
