8
www.hardlifeutility.com
BASE PLATE INSTALLATION
Refer to
Figures 1 and 2
to place the base plates and square tubes for C2020H and C2040H, respectively. All
measurements are from centre to centre of the tubes.
1. Arrange the 2 female square tube base plates used for corners (component code L1) and the 2 male square
tube base plates used for corners (component code L2), as shown in
Figures 1 and 2
.
2. Arrange the 4/12 square tubes for the middle (component code R1) at equidistant points, as shown in
Fig-
ures 1 and 2
.
3. Fix the base plates, square tubes, and connectors used for fixing the square tubes (component code 15)
using the 10 X 60 mm bolts (component code 16); refer to
Figures 1, 2, 3, 4, and 5
.
4. Insert the 30 X 50 mm plastic plugs used for the square tubes (component code 12) into the ends of the
female and male square tube base plates, L1 and L2.
Installing the Square Tubes on the Container
Figure 3
: Fixing the connector (component code 15) to the square tube
Figure 4
: Fixing the square tubes for the middle (component code R1)
8
www.varnabuildings.com
