Varma Tec HED66GBK-120PS, Installation, Operation & Maintenance Instructions Manual

Page: 6 / 24

6
WIRING INSTRUCTIONS
Note: Installer must determine how the heater will be controlled (ON-OFF) and provide branch circuit
equipment as needed. This heater is provided with a section of weatherproof flexible power cable to allow
for ease in wiring. Installer must bring branch circuit wiring to area near heater location and provide an
approved junction box for making connections. Note: Do not install heater directly below a junction box.
1. Route heater cable to junction box and cut excess
cable to allow approximately 6 inches of cable inside
box for wiring connections.
2. Install appropriate cable clamp/strain relief to cable
and secure into junction box.
INITIAL CHECK OUT
1. After all wiring has been completed, energize the heater circuit by turning on the breaker or disconnect
switch provided. Heater should immediately come on.
2. Allow heater to operate for at least 10 minutes to verify all wiring is correct.
3. Disconnect power.
OPERATING INSTRUCTIONS
1. Your heater operates using infrared short wave technology to heat objects, not the air. Therefore, the
heater installation should direct the rays towards the object(s) needing heat.
2. Your heater comes completely assembled except for the attachment of the heater to the wall bracket.
Do not operate your heater unless it is properly installed as indicated in the INSTALLATION
INSTRUCTIONS section.
3. To operate, energize the electrical circuit to heater by turning on the breaker or disconnect switch
feeding the heater. Heater should immediately come on with bulb lighting up.
CAUTION
TO AVOID A POSSIBLE FIRE DO NOT PLACE ANY OBJECTSCLOSER THAN 7 FT (2.1 M) IN
FRONT OF HEATER OR 36 " (914 MM) FROM SIDES..
CAUTION
NEVER STARE AT BULB DURING OPERATION AS THIS COULD CAUSE A POSSIBLE EYE
INJURY.
TO PREVENT A POSSIBLE ELECTRIC SHOCK
HAZARD,MAKE SURE ALL POWER COMING
TO HEATER IS OFF AT
MAIN DISCONNECT BEFORE WIRING.
WARNING