VARISCO GS Series, Operating And Maintenance Manual

Page: 29 / 72

Pompa ad ingranaggi - Serie GS, GK
Gear pump - GS, GK Series
29
1. GENERAL INFORMATION
1.1 SUPPLY CONDITIONS
According to agreements with the Customer, the pump can be supplied either as bare shaft
or pump unit. By pump unit we mean the pump coupled with the motor, including reduction
gears and/or speed variators, if any.
1.2 MANUFACTURER
The pump Manufacturer is VARISCO S.r.l.. You can apply for assistance by sending a re-
quest to the following address:
Via Terza Strada, 9 - 35029 PADOVA - ITALY
Tel. +39 049 8294111
Fax +39 049 8294373
E-mail:
italia.varisco@it.atlascopco.com
export.varisco@it.atlascopco.com
1.3 USER MANUAL CONTENT
This user manual provides all the necessary information to ensure a safe and correct use of
the machine. It was written – when applicable – according to point 1.7.4 of Directive
2006/42/EC, to Standard EN ISO 12100 (Safety of machinery - General principles for design
- Risk assessment and risk reduction) and to Standard UNI EN 809 (Pumps and pump units
for liquids - Common safety requirements). In this manual it is constantly referred to safety
instructions. Such instructions are identified by the following symbols:
It represents the safety instructions contained in this manual,
whose non-observance may compromise safety.
It is shown when electrical safety is essential to worker protection.
It indicates the safety instructions which should be taken into ac-
count for the safe operation of either the pump, the pump unit or
the pump or pump unit protection.
VARISCO S.r.l. declines all responsibility regarding consequences deriving from use of the
pump not in compliance with what is specified in this manual or when ordering.
TRANSLATION OF THE ORIGINAL
INSTRUCTIONS