Variquest Awards Maker 400 Instructions Download Page 4

Page: 4 / 4

1-800-328-0585 www.variquest.com

Step 3: Close the Print Head

Close the print head by firmly pressing
down until it snaps in place on both
sides.

(

Tip:

to ensure proper closure, tap each release lever

with your finger. If it springs up, the print head has not
been properly closed. Push down firmly on that side to
lock.)

You’re now ready to print using your
VariQuest Design Center Software!

Questions: Please refer to your User’s
Guide or contact your VariQuest-
Authorized Dealer.

Varitronics Technical Support can be
reached at 1-800-328-0585.

Summary of Contents for Awards Maker 400

Page 1: ...Awards Maker 400 Installing Supplies Instructions...

Page 2: ...dia underneath the print head with sticker side facing up z Adjust left and right media guides to ensure snug fit z Make sure the leading edge sits on top of the rubber roller To prevent waste do not...

Page 3: ...l Tip hold the bare roll with your left hand and supply roll with your right Wind the ribbon a few times by turning the bare roll clock wise z Insert the supply roll into the bottom holder by pushing...

Page 4: ...sure tap each release lever with your finger If it springs up the print head has not been properly closed Push down firmly on that side to lock z You re now ready to print using your VariQuest Design...