Introduction
The user-friendly 2GIG Vario LCD/LCD Proximity keypad enables simple operation and programming of the 2GIG Vario system.
The following instructions offer a brief overview of keypad operation. For detailed information on programming the system refer to the 2GIG Vario System
Installation and User manuals.
Keypad Indicators
Power
On
System is operating properly from AC power, its backup battery is in good condition, and there
are no troubles in the system.
Off
No power.
Slow Flash
System is in programming mode.
Rapid Flash
System trouble (fault).
Ready
On
System is ready to be armed.
Off
System is not ready to be armed.
Slow Flash
System is ready to be armed (set) while exit/entry zone is open.
Arm (Set)
On
System is armed in Full Arm or Stay Arm mode.
Off
System is disarmed (unset).
Slow Flash
System is in Exit Delay
Rapid Flash
Alarm condition.
Stay/Bypass
(Part Set/Omit)
On
System is in Stay Arm or Zone Bypass (Omit) mode.
Off
No bypass zones in system.
Tamper
On
Zone/keypad/external module has been tampered.
Off
All zones are operating normally.
Fire
On
Fire alarm.
Off
Normal operation.
Flashing
Fire circuit problem.
LED (Red)
Arm/Alarm
Behaves in the same manner as the
indicator.
2GIG Vario LCD Keypad Installation & User Guide
6
Copyright © 2016 Nortek Security & Control LLC