Varimixer V150PL, Spare Part And Operation Manual

Page: 8 / 36

8
Fig.5
Maintenance and lubrication:
The infinitely variable gear must be lubricated regularly, i.e. a lubrication interval of approx. 60 hours of operation.
Lubrication of infinitely variable gear:
OBS . Special grease !!(Use the grease gun delivered together with the mixer). Start the mixer and increase the speed to approx. 50%.
Stop the mixer and disconnect the power cable. Open the lid on the top of the mixer. On the top of each of the two pulley set shafts
is a grease nipple (fig. 5) . Press grease through the grease nipples.until the grease gun feels hard to press or until grease comes out
between the shaft and the pulleys.
The mixer must not be started until the lid is closed and the screws which hold the lid are
inserted.
Start the mixer, and set the speed back to low speed.
Stop the mixer and fill the grease gun with new grease so that it is ready for next time.
Lubrication of other movable parts:
The movable parts of the bowl arms as well as the shaft must be lubricated with oil.
Disconnect the power cable. Remove the rear covering and lubricate the marked points with an oil can.
(fig.5a)
Grease types:
Grease for the pulley set shafts: Castrol High Temperature Grease.
On repair of the planetary head: Grease the toothed wheel and the toothed rim with Nye Gel 868VH,(PN 868VH), the needle bearings
in the planetary head must not be lubricated with this type of grease they should be lubricated with PN Sapphire 2 . Do not use any
another type of grease than the one stated here.
Fig.5a