Varimixer V100PL, Operating Instructions Manual, Page: 9 / 44

9
Recommended maximum speeds:
fig.4
Maintenance and lubrication:
The infinitely variable gear must be lubricated regularly, i.e. a lubri -
cation interval of approx. 60 hours of operation.
Lubrication of infinitely variable gear:
OBS
. Special grease !!(Use the grease gun delivered together with
the mixer). Start the mixer and increase the speed to approx. 50%.
Stop the mixer (use the emergency stop) and open the lid on the
top of the mixer. On the top of each of the two pulley set shafts is
a grease nipple
(fig. 4 point 1)
. Press grease through the grease
nipples.
until the grease gun feels hard to press or until grease comes out
between the shaft and the pulleys.
The mixer must not be started until the screws which
hold the lid are inserted.
Start the mixer, and set the speed back to low speed.
Stop the mixer and fill the grease gun with new grease so that it is
ready for next time.
Lubrication of other movable parts:
The movable parts of the bowl arms, the shaft and the lifting rod
must also be lubricated with oil. Remove the rear covering and
lubricate the marked points with an oil can. (fig.4 pkt.2)
Grease types:
Pulley set shafts: TOTAL MULTIS XHV 2 .
Planetary head: Only to be repaired by an authorised technician.
Toothed wheel and the toothed rim
special grease Nye FLUROCARBON GEL 868.
Needle bearings Special grease PN Sapphire 2.
On repair of the attachment hub: Fill the attachment hub
with TOTAL CERAN CA
Do not use any another type of grease than the one stated here.
1 2 3 4 5
MIN MAX
Recommended maximum speeds
for attachment hub (V80):