VARILITE VLZ SPOT, Quick Start Manual

Page: 13 / 22

13
Step 3. Use four Arrow ( ) buttons to navigate through the various options and settings.
Step 4. Once menu item is reached, press OK [Enter] to access the menu item parameters.
Step 5. Make changes to parameters as desired.
Step 6. Press button to accept changes.
Other LCD Display Features
LCD Menu Battery Operation
The LCD menu system utilizes a battery powered system for operation when the luminaire is not connected to power. The primary
purpose of this mode is to allow basic setup and configuration of the luminaire.
To enable the battery operation of the menu system:
Step 1. Press [Mode] three seconds to activate display!
Step 2. Once enabled, the menu will function as normal with only the following sub-menu sections active:
 Address
 Configure
 DMX
 Fixture
Note: Any commands that require full power (calibrate, etc.) will be ignored while the menu system is in battery operation mode.
Step 3. To exit battery mode, press [MODE/ESC] three seconds.
Status Bar
The Status Bar (as illustrated in Figure 7 ) is present at all times and displays
luminaire operational information of the luminaire. The Status Bar contains the
following information:
 LED - indicates current lamp state - ON or OFF.
 ERRORS
– Displays a number indicating the total amount of current errors. When
errors are present, messages will appear in Red text. When no errors are present, NO
will display.
 SHDN – indicates hibernate mode – YES or NO
 MODE
：
indicate fixture power mode
，
STA- Standard Mode
，
STE-- Studio Mode
 MAP
– Displays the current DMX map mode setting. 16E--16-bit Enh Mode;16 — 16 bit Mode
 ADDR – Displays the current DMX address for the fixture. NOTE, when the fixture does not detect a DMX input signal, the
DMX address text will display in Red text.
Figure 7: LCD display Status Bar