MSC-10
Page
21
LIST OF ABBREVIATIONS
b) Remove the screws (2) and the access plate (1) of the MSC-10.
c) Locate the configuration module (10) and insert the config module
into the socket on the main board. Ensure the arrow of the config
module is pointing the same way as shown on the main board.
d) Turn on the power source. The digital display on the front panel
should indicate
dnLd
(or d)
for approximately one second. If
dnLd
(or d)
is not displayed, attempt one more time. If display is still not
responding, remove and replace the config module (ensure the
polarity is correct).
e) When the download procedure is successful remove the config
module and place it in its storage location (8).
NOTE
If the config module is not removed after the download
procedure, the control values will return to a reset status
every time a power failure occurs and when the power source
is reactivated.
LIST OF ABBREVIATIONS
d
download
DPDT
Double Pole Double Throw
DRT
Desired Room Temperature
°
F
degrees Fahrenheit
°C
degrees Celcius
Hz
Hertz
LED
Light Emitting Diode
mA
milliampere
RSP
Relative Set Point
VAC
voltage alternating current
www.monitrol.com
