Varifan IC-610, User Manual

Page: 13 / 44

Page 13
Use a screwdriver to remove the 3 screws of the top
faceplate and the 3 screws of the access panel. Then,
open both faceplates.
•
Install mounting screw on wall and hang the unit in
place by sliding the rear mounting hole of the IC-610
over the screw (see figure 1).
•
Use two more screws to secure the IC-610 in place
using the bottom mounting holes.
2.3 CONNECTION PROCEDURE
For the following connection procedure, refer to figure 2.
ELECTRICAL CONNECTIONS
The installation of the IC-610 and its connections to the
various control modules should be well-planned for
optimal performance and ease of use. The following
guidelines are given to help establish the best installation
configuration for your building and for the overall safety of
people and livestock.
2.3.1 Electrical Power.
Locate the power source of your building and install the
IC-610 in the most convenient location. Protection from
electrical surges should be included in the planning of
each installation. The IC-610 electrical power default is a
230 VAC power source. It is also able to run on 115 VAC.
2.3.1.1 - Line Voltage Selector Switch
This switch is located on the surface of the main
(bottom) board and adapts the IC-610 to 115 VAC
or 230 VAC line voltage (see figure 2).
Mounting hardware is not included.
230V
115V
−
ATTENTION
−
Set the line voltage switch inside the IC-610 to the correct
value before powering up the Intelligent Control.
www.monitrol.com