KAPITEL 3 - BETRIEBANWEISUNG
92
87-900-045-01
(D)
In der Anzeige erscheint Abbildung 3-11 wenn die
Batteriespannung zwischen 11,2 und 10,2 Vdc liegt.
B a t t e r i e t e s t
B A T T E R . S C H W A C H B
Abbildung 3-11
Wenn diese Anzeige erscheint muß die Batterie
geladen werden.
Nach weiteren 4 Sek. erscheint in der Anzeige
Abbildung 3-12.
E
m
p f . t e
s t
*
Abbildung 3-12
Dieser Test prüft die Empfindlichkeit von HeliTest.
Dafür muss sich etwas Helium in der Sondenleitung
befinden.
Nach 1 Minute ist der Test beendet und auf der
Anzeige erscheint Abbildung 3-13.
E
m
p f . t e
s t
O K
*
Abbildung 3-13
Ist der Empfindlichkeits Test nicht positiv, erscheint auf
der Anzeige Abbildung 3-14:
E
m
p f . t e
s t
D E F E K T
*
Abbildung 3-14
Die Meldung wird über eine Minute angezeigt,
anschließend schaltet sich der HeliTest automatisch aus.
In diesem Fall ist die Startprozedur zu wiederholen. Falls
erneut die gleiche Meldung angezeigt werden sollte,
wenden Sie sich bitte an die Verkaufsabteilung.
Is der Empfindlichkeits-Test erfolgreich abge-
schlossen, erscheint der nächste Schritt auf der
Anzeige Abbildung 3-15.
S e n s o r T
e s t
*
Abbildung 3-15
Nach 1 Minute ist der Sensor geprüft, auf der Anzeige
erscheint Abbildung 3-16 wenn der Sensor O.K. ist;
andernfalls erscheint Abbildung 3-17.
S e n s o r T
e
s t
O K
*
Abbildung 3-16
S e n s o r T
e s t
S T I C K S T O F F S P R . *
Abbildung 3-17
Diese Anzeige erscheint solange bis die
vorgeschlagenen Schritte getan wurden, oder der
HeliTest abgeschaltet worden ist (siehe Anmerkung).
ANMERKUNG
- Entfernen Sie den HeliTest aus der Nähe von
Heliumquellen.
- Sofern vorhanden, Stickstoff (N2) oder
Argon (Ar) auf die Sonde sprühen, bis am
Display die Anzeige gemäß Abbildung 3-16
erscheint (binnen maximal 15 min).
- Wiederholen Sie den Eigentest gemäss
Paragraph
3.2.
Sollte der Sensor Test immer noch "STICKSTOFF
SPR." zeigen, rufen Sie das nächste Büro an.