4.
Assembling the Privacy Booth
1
Place Panel 1 on Side 1 of the base (see above diagram), aligning the pre-installed Striplox
™
Hooks on the panel with the Striplox
™
Hooks on the base. While someone holds the panel
in place, insert the Striplox
™
Connectors into both of the bottom joints. (See Striplox
™
instructions on page 3 for clarification.)
DO NOT
release Panel 1 until Panel 2 is secure.
SIDE 2 (BACK)
SIDE 4 (FRONT)
SIDE 1 (LEFT)
SIDE 3 (RIGHT
/PO
WER)
TOP VIEW
OF BASE
To ensure the base is secure and level, use a 13mm socket wrench on each of the four nuts,
adjusting the leveling feet so they extend below the casters. Once the leveling feet are
engaged and the base panel is level, orient the base in position by identifying the side with
no Striplox
™
hooks installed; this is the front edge of the base.
FRONT SIDE OF BASE
FRONT
SIDE OF
BASE
2
