KC-435
17
1.5.2
Sharpening the cutting blades of the grass blade
Perfect results of the cutting tool can only be ensured if the
blades are properly sharpened. Slight sharpening can be done with a
hand sharpening stone. For bigger blunting it is necessary to use a
tool sharpener.
In any case it is necessary to pay attention to
perfect balancing of the blade during the
sharpening. If you don’t have suitable tools or you
are not sure about the correct balancing of the
blade, contact a service shop.
Dismount the cutting blade and inspect it properly
to find out if it is not burst, bent or in another way
damaged. If any damage occurs, replace the blade
with a new one. The cutting blade can be used
from both sides. If the blades become blunt at one
side, the blade can be turned over and the blades
on the other side can be used.
Sharpen the blades only on the part intended for
sharpening. When sharpening, pay attention to
keep the sharpening profile, so that the cutting
blade is not destroyed at work. All the teeth of the
blade are to be sharpened in the same way.
If
you
notice
abnormal
vibrations
after
sharpening, it is obvious that the blade is not
balanced correctly. In such a case, contact your
service and give them your blade to check it. If the
blades are worn out over the given limit, replace
the blade with a new one.
A
– wrong sharpening
B
– right sharpening
1
– Place of possible destruction
2
– Limit for the tooth shape
3
– Wrong sharpening angles
4
– Sharpening boundary
5
– Sharpening limit
1.5.3
Maintenance and adjusting of the engine
Maintenance and adjusting of the engine – see the instructions for use of the engine
13
1.5.4
Angle gearbox lubrication
Remove the bolt (1) at the side of the
gearbox.
Squeeze a special lithium Vaseline
(available at Honda dealers) into the
opening (2) and continue squeezing the
Vaseline until it starts to get back from
the opening (2).
Close the lubrication opening with the
bolt (1) and tighten it properly.
!
When working with lubricants, observe
the basic hygienic rules and regulations
and laws concerning the environmental
protection.
13
The original instructions for use and its translation are part of the machine.
