Vari Hurricane MaX F-580BiS, User Manual, Page: 35 / 64

Hurricane MaX
Problem Cause Solution
The engine cannot be turned
OFF
Electrical installation defect Wait for an empty petrol tank, visit a service
centre
The engine control string does not control the
shortening contact Wait for an empty petrol tank, visit a service
centre
Other defect Visit a service facility
The working tool cannot be
stopped
The tension pulley does not return back to its position Lubricate
The control levers do not
return back. The inner bowden cable is stiff; bent bowden cable Lubricate or replace the bowden cable
Broken return spring Replace with a new one
Other defect Visit a service facility
Other defect Visit a service facility
Table 21: Troubleshooting
2.5.7 S
TORAGE
Prior to any long-term storage (e.g. at the season end) remove all the dirt and plant residues from the machine. Prevent any
unauthorized persons from accessing the machine. Protect the machine against climatic conditions but do not use impermeable protection
to prevent excessive corrosion it may cause.

We recommend having your machine prepared for the next season at some authorized service centre. Before a season,
the service network is usually fully utilized.
We strongly recommend the following steps:

Preserve any working tool worn areas.

Remove all the dirt and plant residues from the machine.

Repair any paint damage.

Drain the fuel from the fuel tank and carburettor (further instructions in the engine operating instructions).

Lubricate the machine, as recommended - see
Table 13
.

Check the tyre pressure and inflate the tyres to their MAX value specified in Chapter 2.5.1.1 .

Store the battery per the instructions in the engine operation manual.
2.5.7.1 M
ACHINE WASHING AND CLEANING
When washing and cleaning the machine, proceed so as to observe valid provisions and laws regarding protection of water courses and
other water resources against pollution or contamination by chemical agents.

Never wash the engine by a water jet! During starting, the engine electric system could malfunction.

Do not wash your machine with a pressure washer!
2.5.8 D
ISPOSAL OF
P
ACKAGING AND THE
M
ACHINE AT THE
E
ND OF ITS
S
ERVICE
L
IFE

When you unpack the machine you are bound to dispose of the packaging material according to national laws and
decrees concerning waste disposal.
When disposing of the machine at the end of its service life, we recommend proceeding as follows:

Demount from your machine all the parts that may still be used.

Drain oil from the engine into a suitable closing container and dispose it in a waste collection centre 91 .

Return the battery and charger to a waste collection point.

Remove any plastic and non-ferrous metal parts. Sort your waste.

The remaining machine and its removed demounted parts are to be disposed of according to national laws and decrees
concerning waste disposal.
91
The respective local authority will inform you of the disposal centre location.
35
Re
vi
ze
1
0/
20
19