EN
8
2.
Press on the purge bulb under the
carburettor 4 or 5 times, to allow the
gasoline to arrive on the return fuel
tank transparent gasoline pipe.
3.
Move
the
starter
lever
of
the
carburettor in this position.
4.
With your left hand, grip the
brushcutter (make sure that the
machine is well-balanced and the
handles are in suitable position for you)
and with the right hand pull slowly the
handle recoil starter until the pawls
hook onto the flywheel.
5.
Pull hardly 4 or 5 times the handle
recoil starter until the starting, the red
button return on <<OFF>> position
when you push on the gas lever.
6.
Release the starter lever after starting
on this position
.
7.
Never pull the recoil starter to its all
length in order to avoid damages to
the recoil starter.
If the engine does not start, maybe the
spark plug is wet. In this event, unscrew
the spark plug, wipe and dry it and pull the
recoil starter several times, without the
spark plug in place, in order to clean and
ventilate the combustion chamber.
IMPORTANT:
Whenever the engine is hot, all these
operations are not necessary, pull only
the recoil starter until the engine starts.
The cutting device should not be in
rotation at the idle speed of the engine.
Running-up
During the first ten hours of work, run the
engine at a moderate rpm. We advise you,
in any case, do not use your engine at high-
speed as the different components must
adjust one with the others during the
running-up period. It is at the end of the
running-up period that the engine will
reach its maximum power.
After the two first hours of work, make a
pause and check that all nuts and screws
are securely fastened, tighten if necessary.
USE OF THE BRUSHCUTTER
Which protection to use with which
cutting tool?
Always use the safety guard supplied
with the brushcutter.
Use only the tools supplied by the
manufacturer. All other blades and
especially
saw
blades
are
FORBIDDEN.
This brushcutter is only made to cut grass,
bushes, arborescent shrubs and clumps.
* Be sure that the weight of the machine is
perfectly balanced between the engine and
the cutting system. The cutting tool must
be parallel to the ground.
* Operate a few accelerations, without
reaching the max. rpm and without
working to make sure that everything is
working in good condition and regularly.
* Only when the nylon head or the 3-teeth
blade is at complete stop, you can go to
your working zone by carrying the
machine in a way that the cutting tool is
under your waist level and far from your
body. Make sure there are no other people,
animals or others within a 15 meters
radius.
36
0°
15m 50
f t
Place yourself in a well-balanced and
stable position on both feet.