Vari Lite VL2500 Spot Luminaire, Service Manual

Page: 30 / 168

VARI
❋
LITE ® - VL2500™ W
ASH
L
UMINAIRE
S
ERVICE
M
ANUAL
12 09-December-2004 02.9676.0022 0
Testing
Testing Software
Testing software is available in all Series 2000 luminaires through the luminaire’s
menu system
TEST function.
For information on specific tests and test parameters, see the VL2500 Wash Luminaire
User’s Manual (VL Part no. 02.9676.0021).
When running tests on multiple luminaires, a loopback connector is required at the
first luminaire in the link and a male termination connector is required at the last
luminaire.
Note: After 10 seconds of inactivity, the menu display will change to the default state
showing the address.
Move Disable
The Move option is available in the test menu. This allows for pan/tilt functions to be
disabled so that the luminaire can be placed in any position for testing without
movement occurring. In order to regain full control of the luminaire,
Move will need
to be enabled after testing.
Note: When setting the Move option to disable, luminaires linked by a loopback
connector will have pan and tilt disabled for all the luminaires that are linked.
Lamp
The Lamp option is also available in the test menu. This option sets the lamp
intensity to 100% and will adjust to produce a tight beam. Pan/Tilt are disabled while
using the
Lamp option, and pan/tilt settings will be restored upon exit of the Lamp
feature.
Note: When setting the Lamp option on luminaires linked by a loopback connector,
pan and tilt will be disabled for all the luminaires that are linked.
To run tests:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until TEST appears. Press [Enter].
Step 3. Use [Up] / [Down] arrows to select a parameter to test.
Step 4. Press [Enter] to run test.
Step 5. Press [Menu] to stop test at any time.