M
AINTENANCE
: M
AINTENANCE
P
ROCEDURES
2
0 2 . 9 6 7 3 . 0 0 1 0 D
2 4- Ma rc h- 2 0 04
23
Step 8. Re-install front assembly by performing Steps 2–6 in reverse order. While re-
installing, first connect wiring harness connection to rotating gobo wheel
sensor and route wires through corner between head assembly and bulkhead
(ensuring no wires are pinched).
Rotating Gobo Sensor PCB Replacement
Parts:
24.9667.0321
1 EA
PCB ASSY, SENSOR ROTATING GOBO
Tools:
Screwdriver, #1 Phillips
Screwdriver, #2 Phillips, long handle
To remove and replace rotating gobo sensor PCB:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove front assembly. Refer to
“Front Assembly Removal” on page 22
Step 3. At rotating gobo wheel, remove two 4-40
×
3/8" PFZ screws (do not remove
middle screw) and remove wheel.
Figure 2-9: Rotating Gobo Wheel Removal
Center Screw
Do Not Remove
4-40
×
3/8”
PFZ Screws
Rotating Gobo Wheel
Rotating Gobo Sensor PCB
Summary of Contents for VL2000
