I
NSTALLATION
: P
OWERING
U
P
2
0 2 . 9 6 6 5 . 0 0 0 1 0
1 5 F e b r u a r y 2 0 1 1
21
Standard Power Up Procedure
Use this procedure when powering up a luminaire that has already been configured. (Refer to
“Power-
Up and Configuration Overview” on page 20
.)
Note:
Refer to
Chapter 4:
Menu System
for detailed instructions on menu functions.
CAUTION:
Before applying power, be sure the luminaire is hung or positioned so that the head and
yoke can move freely without restriction.
To power up luminaire:
Step
1. At each luminaire, apply power by switching on power source. Luminaire will display
Starting
for 10-15 seconds, and then automatically step through the following procedure:
1) If Lamp Power-Up State is set to
Lamp On
, lamp will strike (ignite).
2) Luminaire will cycle through calibration and stop at "home" position.
3) If Lamp Power-Up State is set to
Cal On
, lamp will strike (ignite) at end of
calibration sequence.
4) If Lamp Power-Up State is set to
Lamp Off
, them Luminaire will cycle through
calibration and stop at "home" position. Lamp will not strike (ignite) until a Lamp
On command is received by luminaire.
Summary of Contents for VL1100CD
