VARI
❋
LITE - VL1100 LED L
UMINAIRE
Q
UICK
S
TART
G
UIDE
02.1602.0001
24 April 2017
6
For three-phase power at 200 volts RMS:
WARNING:
It is not recommended to power any VARI
❋
LITE luminaire from a dimmer - even in 'NONDIM' mode. Dimmer and non-dim
modules are not suitable sources of power because their output modifies the AC wave form. This may work for a short time, but will
eventually result in power problems, luminaire mis-operation and/or failure and may void the luminaire’s warranty.
AVERTISSEMENT:
Il
n'est pas recommandé pour alimenter un luminaire VARI
❋
LITE d'un gradateur - même en mode 'NONDIM. Modules de gradation et non
sombres ne sont pas des sources appropriées de pouvoir parce que leur production modifie la forme d'onde AC. Cela peut fonctionner
pendant une courte période, mais finira par entraîner des problèmes d'alimentation, luminaires mauvais fonctionnement et / ou l'échec et peut
annuler la garantie de l'appareil.
Current vs. Voltage
Table 1-1, VL1100 LED Luminaire - Current vs. Voltage (460W LED Source)
provides the luminaire’s current draw at specific voltages.
Total Luminaire Current is calculated with the lamp on and all motors sequencing.
WARNING:
It is the responsibility of the user to adequately protect supply source with a correct size and type circuit breaker and not
overload circuits.
AVERTISSEMENT:
Il est de la responsibilité de l'utilisateur de protéger adéquatement la source d'alimentation avec une
taille correcte et le disjoncteur de type et surchargez pas les circuits.
Connecting Data
A maximum of 32 luminaires may be connected in any one DMX data link.
Note:
This maximum limit applies to the luminaire "daisy chain" only. Your system or console may require fewer luminaires on a single data
link path. Consult your console documentation for more information.
To connect power and data:
Step
1. Connect data cable from console to first luminaire in chain at DATA IN connector.
Step
2. If required, connect additional data cables from DATA THRU connectors to DATA IN connectors of remaining luminaires in
link.
Connection
Pin
Phase 1
X
Phase 2
Y
Ground (Earth)
G
Table 1-1: VL1100 LED Luminaire - Current vs. Voltage (460W LED Source)
AC Voltage @ 60Hz
Total Luminaire Current (Motor + LED Current)
100V
6.3A
110V
5.7A
120V
5.2A
130V
4.8A
200V
3.1A
210V
3.0A
220V
2.8A
230V
2.7A
240V
2.6A
X
Y
G
