VAREL RXFM6, Manual

Page: 6 / 30

ENGLISH
6 - E
TRANSMITTER PAIRING
Every transmitter has a unique code, it is necessary to pair the transmitter with the
receiver, only commands from the recognized transmitter will be executed.
To pair a new transmitter:

Open the right light, without disconnecting the cable;

Connect the transmitter to the vehicle, make sure no other TL-TX transmitter
is transmitting nearby (100m);
 Switch ON the vehicle’s tail lights, switch ON the light set and press the ‘ACQ’
pushbutton on the receiver’s board;

The right tail light will blink, release the pushbutton and turn off the vehicle’s
tail lights;
 Activate the vehicle’s lights and verify that the repeated lights are working
correctly.
The procedure is over, the right light can be closed.
If the procedure has not been successful it must be replaced
Should a need arise to clear the transmitter pairing (for example in case of a pairing
error) you can follow this procedure:

Open the right light without disconnecting the cable;

Turn OFF the lights, disconnect any nearby transmitter, press and maintain
pressed the ACQ pushbutton;

Turn ON the lights and wait 10 seconds, the right tail light will blink indicating
that the memory is erased, release the pushbutton.
It is now necessary to pair a transmitter to operate the lights in RADIO mode.