VLC5501 Vapormatic Immobiliser Installation Manual
10 of 21
Keypad installation:
Mounting of the Keypad module:
The Vapormatic keypad module transmits an authorisation code to the two immobiliser blockers
wirelessly, unblocking the electrical system and allowing the vehicle to start. The keypad module must
be installed in a dry location normally inside the vehicles cabin providing easy access to the keypad
buttons.
Keypad installation procedure:
Location of the keypad is very important, it should be placed in an easy to see and use position
with no obstructions. The desired location must have sufficient room behind to accommodate
the four screws and keypad wiring.
Using the keypad mounting plate (2) as a template, drill four small pilot holes for the
mounting screws.
Using the four screws provided, screw the mounting plate to the desired surface.
Drill one final hole into the mounting surface to allow for insertion of the keypad wiring.
Pull the keypad power cable through the drilled hole, then clip together part 1 and part 2 as it’s
shown on the Figure 1 below.
Follow the keypad wiring diagram to complete the keypad installation procedure.
Fig1
1
2
