QUICKSTART GUIDE
DIRECTIONS FOR USAGE
1.
Always pre-grind your herbs, it is important that you finely grind your
herbs to allow heat to penetrate all surface areas for maximum benefit.
2.
Set the unit to your desired temperature*. Using the + and - buttons
you can toggle through exact temperature settings in order to find the
one you desire. It does take a little practice to find the perfect
temperature for your liking. In the meantime, here is a good guideline to
follow: if you are not getting enough flavor, turn the temperature up. If
your herbs are burning then turn the temperature down.
3.
When you have set your desired temperature, engage the heating
element by pressing the Heat Button (Red Button located beneath the
LCD Temperature Display). Once this button has been pressed a Red LED
light will illuminate above the LCD Temperature Display indicating the
heating process has begun.
4.
Now that the unit has reached the desired temperature the Red LED will
change to a Green LED, indicating the unit is fully heated and ready for
usage.
*
Please note, the temperature will change inside the unit causing the
temperature to drop slightly and the Green LED will revert back to a Red LED
indicating the unit is re-heating to reach your desired temperature. This is
normal and will occur during usage.
**Vapir recommends plugging your NO2 into a surge protector while using in
AC mode.
1.
Grind Your herbs
2.
Turn the Unit On
4.
Press Red Button to Engage Heat
5.
When LED Turns Green, Remove Top
& Insert Herbs
(approximately 3/4 full or less),
Replace top then inhale and enjoy!*
3.
Set Desired Temperature
Not enough flavor? Turn temperature up.
If herbs are burning? Turn temperature down.
*For best draw it is suggested that you use the included tube.
3
4
