Vapir Digital Air, User Manual

Page: 4 / 20

D
WARNING: THIS UNIT AND MANY OF ITS COMPONENTS GET VERY HOT! READ ALL
DIRECTIONS AND HEED ALL CAUTIONS CAREFULLY BEFORE USING THIS DEVICE. SERI-
OUS INJURY MAY RESULT FROM IMPROPER OPERATION.
MAKE SURE BATTERIES ARE FULLY CHARGED, OR UNIT IS PLUGGED IN AND IN ‘ADP’
MODE, OR IN ‘ON’ MODE (FOR CORDED MODELS) BEFORE STARTING.
FILL & INSERT HERB DISK
Prepare herb disks. Add essential oils or other liquid before closing herb disk.
Optional: Remove Cap by gently turning counter clockwise and insert tube attachment.
Eject 'Herb Disk Drive' by pulling down on door and pulling the drawer out.
Insert herb disk into 'Herb Disk Drive' and place drive back into unit.
Lock Drawer by pushing top portion of drawer up until you hear a 'Click'.
Slide switch at the bottom of the unit to either 'BAT' or 'ADP'. Select 'BAT' for battery oper-
ation. If plugged in, select 'ADP' is for adapter operation.
A
B
C
D
E
F
SET TIME
Press both + and - buttons at the same time.
Press or - button to increase or decrease the amount of time you want the unit to stay on.
Press 'Heat' button. Unit will turn off, indicating that time has been set.
Press 'Power'.
Press or - button to increase or decrease the desired temperature.
Press ‘Heat’ button to activate.
Wait for vapor/aroma to form (usually 2-3 minutes, depending on material used).
Enjoy Aroma.
Your unit comes equipped with digital heat controls; however, the heat can also be regulated
manually.
A
B
C
QUICKSTART GUIDE QUICKSTART GUIDE
E
F
G
H
Wait for vapor/aroma to form (usually 2-3 minutes, depending on material used). When you see
any visible vapors, immediately press the heat button to turn heater off and to prevent overheat-
ing of materials before enjoying the aroma. When you are ready to enjoy the aroma, press the
‘Heat’ button again until more vapor appears, and then press ‘Heat’ again to turn heater off
before enjoying aroma. Repeat as necessary. Similarly, you can the eject the herb disk immediate-
ly after each use (several times during the session) for maximum effect.
MANUAL HEAT REGULATION
CHARGING
Unit does not charge when in 'ADP' or ‘BAT’ mode. To charge, the unit must be in 'CHA’ mode.
TUBE ATTACHMENT
The optional tube attachment is for flavor delivery purposes. Never put your mouth to the outlet
valve, it may be hot. Always either use a tube or taste the flavor from a distance of several cen-
timeters without touching the outlet valve.
Note: Tube fits extremely tightly!
3 2
• Insert tube before use.
• Grind herbs in either our Max™ or Maxine™ Herb Grinders (sold seperately) or in a coffee grinder.
• Preheat Vapir™ unit to 250°F with the drawer out. Wait for light to turn green, then insert the
disk drive.
• Inhale the flavor immediately upon insertion.
• When inhaling, breathe deeply. Hold the vapor in. Repeat for 10-15 minutes.
• Remember, visible vapors will not always be present.
• Always either inhale the flavor or eject the drive when vapor begins to escape through the vents.
Also see Frequently Asked Questions on page 13.
QUICK TIPS