Vapioneer Vision Mod, User Manual

Page: 4 / 21

- 3 - - 4 -
Attention: If the screen shows ‘CHECK
ATOMIZER’ when pressing power button to
vape, please make sure the atomizer tank
is connected to the battery completely, or
check if the coil is connect to the atomizer
base completely.
3. Press power button three times in two
seconds, the mode selection part will blink,
press ‘+’ button to go to the next mode - ‘M2
BYPASS’, the screen shows Voltage only,
the kit become an un-adjustable mod kit.
4. Press power button three times in two
seconds again, the system switches to
temperature control mode, the mode selection
part will blink, press ‘+’ or ’-’ button can select
coil type - NI200/TI01/SS316, when coil type
is selected, press power button to con
fi rm it.
Press ‘+’ or ‘-’ button to adjust temperature.
The temperature control range is from 100°C
to 300°C in Degrees Celsius, press the ‘+’ or ‘-’
button one short time can add or reduce 1°C,
long press can add or reduce faster. When
degrees Celsius goes up to 300°C and press
‘+’ button one more time, the temperature
unit goes to degrees Fahrenheit. Degrees
Fahrenheit changes from 200°F to 600°F,
one press adds or reduce 1°F, long press
can change faster. When degrees Fahrenheit
goes up to 600°F and press ‘+’ button one
more time, the temperature unit goes back to
degrees Celsius.
5. The ‘P:00001’ on the lower right corner of
the screen is the puff time. Press ‘+’ and ‘-’
button at the same time for three seconds,
the puff time will be reset.
6. Press power button fi ve times in two seconds
to turn off the battery mod, there will be a
‘Vapioneer’ logo, too.
• HOW TO CHARGE BATTERY MOD
There is a micro USB charging jack on Vision
battery mod. Please charge it with the USB
cable in the kit. Charging voltage is 3.0-4.2V;
minimum charging current is 1.0A. The screen
will show a charging indication when battery is
under charging.