FILLING & OPERATION
Fig.1
!
er
Do not ov
!
Make sure the steam gun and hose is plugged into the
machine before startup. Plug the machine into a proper
wall outlet and swit
the pump is running hold the steam gun trigger down
for 15-20 seconds to release the air trapped in the boiler.
Once the boiler is full the pump will stop and the red
status light will light up showing the boiler is now
heating the water. Once the boiler is at operating
temperature the status light turns to green indicating
or
GENERAL FUNCTION:
located on the top of the machine and using the
screen. (Fig.1)
Using additives of any kind will void the warranty.
!
.
internal components and can cause failure to internal parts and void the warranty.
without this screen in place. Failure to do so will void the warranty.
Fig.2
er
NOTE:
Do not ov
!
Cold water
tank fill cap
ST ATUS
PRESSURE
FILL
OUTPUT
ON
OFF
+
_
Water fill light
Status light
On / off
switch
the steamer is ready for use. (Initial start up from cold machine is aprox. 9 min) *The
status light will cycle red to green during use as the boiler maintains the temperature.
The Vapamore MR-1000 Forza has an industry high steam burst pressure of 90 psi. For
situations that need a short high pressure steam burst for cleaning, set the the steam
output to maximum pressure. For large cleaning areas that need a maintained steady
output knob from the full open position, counter clockwise approximately 1/2
revolution. The steam output knob can be turned down further for delicate jobs that
require very little pressure such as jewelry, fabrics, furniture, etc. (Fig.2)
Use steam knob to
adjust steam output level