25799 Jefferson Ave.
Murrieta, CA 92562
1-800-VANIMAN (826-4626) USA
www.vaniman.com
MASTER PROBLAST3 ESD - 08/23 Page 10
MASTER PROBLAST 3 ESD
PROPER GROUNDING PROCEDURE
When setting up your Vaniman ESD Blaster, it is important to correctly ground your system to provide
the best posibible protection against ESD damage to the parts you are blasting. To properly ground your
system, complete the following steps:
1. Using a typical wall outlet, unscrew the middle screw that holds the outlet faceplate to the outlet
body (Fig. 1), but keep the outlet faceplate in place on the outlet once the screw is removed.
2. Plug the power supply into the provided gray outlet adapter, then plug both into one of the wall
outlets so that the adapter's metal tab with a hole in it aligns with the outlet's faceplate mounting
hole (Fig. 2).
3. Take the green wire attached to the power supply wiring harness with the ring terminal on the end
and slide the ring terminal between the metal tab of the gray adapter and the outlet faceplate, with
the holes aligned.
4. Secure the adapter and power supply to the outlet faceplate using the same screw removed in step
1 above. Your ESD system will now be properly grounded.
Fig. 1
Fig. 2
