17
105500
OWNER’S MANUAL
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
freestanding fireplace.
1.
Remove glass door. See Removing/Re-
placing Glass Door, page 16.
2.
Place log #1 (back log) on top of grate.
Make sure the notches in the bottom of
the log fit over the grate (see Figure 40).
2.
Rest log #2 (large front log) on the pins on
the front part of the grate (see Figure 41).
3.
Place log #3 (crossover log) onto the
rear and front logs. Make sure it is seated
properly into the notch on the front log
and over the raised triangular portion of
the rear log as shown in Figure 42.
4.
Place log #4 (small log) onto the front
left part of the grate making sure the
notches fits over the prong of the grate.
See Figure 43.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS, LAVA
ROCK AND GLOWING
EMBERS
FIREPLACE
INSTALLATION
Continued
1
2
3
4
Figure 40 - Installing Log No. 1
Figure 41 - Installing Log No. 2
Figure 42 - Installing Log No. 3
Figure 43 - Installing Log No. 4
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
5.
Lava rock may be placed along sides
and front inside firebox bottom. This
may not be visible when you have re-
placed the front of the stove. It is not
necessary to use all of the lava rock
provided.
Figure 44 - Placing Ember Material on
Burner
6.
Pull ember material apart into pieces
no larger than a dime. Place these
pieces loosely and sparingly directly
onto the exposed section of the front
burner and along the space between the
burner and grate prongs (see Figure 44).
This will create the glowing ember ap-
pearance as the flame touches the em-
ber material. Do not block air slots by
using too much ember material in one
area. It is not necessary to use all of the
ember material provided.
7.
Replace the glass door and stove front.
See Removing/Replacing Glass Door,
page 16.
8.
Place lava rock plate in space between
the front of the cast iron stove and the
glass front of the insert. Place lava rock
on the plate for a decorative appear-
ance. It is not necessary to use all of
the lava rock provided.
