3
104890
Installation Instructions
OPERATING THE BLOWER
The DA3610T thermostatically-controlled
blower has an ON setting and an OFF set-
ting. The blower will only run when the
switch is in the ON position. In the OFF
position, the blower will not operate.
The blower helps distribute heated air from
the fireplace. Periodically check the louvers
of the firebox and remove any dust, dirt, or
other obstructions that will hinder the flow
of air.
Figure 5 - Installing Plastic Bushing for Power Cord and Locating Wiring
Diagram Decal
Plastic
Bushing
WARNING: Never touch the
blower wheel while in operation.
10. Peel off the backing paper and stick the
supplied wiring diagram decal on the
outer casing bottom approximately 3" to
the right of the blower speed control (Fig-
ure 5).
WARNING: Failure to position
the parts in accordance with sup-
plied diagrams or failure to use
only parts specifically approved
with this heater may result in dam-
age or personal injury.
11. Connect or reconnect gas supply fol-
lowing instructions given in the owner's
manual supplied with your fireplace.
WARNING: A qualified ser-
vice person must connect fire-
place to gas supply. Follow all
local codes.
INSTALLING
DA3610T BLOWER
ACCESSORY IN
DIRECT-VENT
STOVE SERIES
BHDV, BDV, DDV,
AND HDV
Continued
Wiring Diagram Decal
8.
Plug in blower power cord.
a. If your fireplace system is installed
as a freestanding unit with an ac-
cessory mantel, determine whether
the power cord will exit the left side
or the right side of the firebox. In-
stall one plastic bushing (provided)
into the 1
1
/
2
" hole in the outer cas-
ing through which the power cord
will exit. Install the second plastic
bushing (provided) into the floor sup-
port bracket if exiting through the
right side (see Figure 5). Route power
cord through (both) plastic
bushing(s) and plug the power cord
into a properly grounded 3-prong
wall receptacle near the firebox.
b. If your fireplace system installation
is recessed and/or pre-wired, a
qualified installer must make all elec-
trical connections for the outlet kit
included with the fireplace.
9.
Check to make sure that the power cord
is completely clear of the blower wheel
and that there are no other foreign ob-
jects in blower wheel. Turn blower on
and check for operation. Turn blower
off by rotating knob fully counterclock-
wise before continuing.
