REV 1.0
VBT-75P S2 USER’S MANUAL
13
3.5
Setting the Option to Print the Calibration Expiration Date
The VBT-75P S2 can print the unit's factory calibration expiration date at the bottom of test
reports if desired. Follow the steps below to configure this option:
a.
Start from the "START-UP" menu:
Press the
[2]
key (
SETUP
).
b.
The following screen will be displayed:
Print the
[4]
key (
CAL PRINT ON/OFF
).
c.
The following screen will be displayed:
1.
Press the
[1]
key to enable the option. The following screen will be displayed:
The calibration date printing option will be enabled and you will be returned to
the "START-UP" menu.
2.
Press the
[2]
key to disable the option. The following screen will be displayed:
Press any key to return to the "START-UP" menu.
CAL DATE PRINTING
DISABLED.
CAL DATE PRINTING
ENABLED.
CAL DATE PRINTING:
1.ENABLE
2.DISABLE
1.ENTER SHOT ID
2.SET TIME
3.SET LANGUAGE
4.CAL PRINT ON/OFF
1.RUN TEST 07/10/17
2.SETUP 11:01:00
3.RECORDS
CABLE VTG: 0V