V&P Scientific, Inc.
2
Technical Note 269C
SET-UP
CONNECTING PARTS OF THE SpinVessel® SYSTEM
1.
Place Motor Unit on a sturdy lab bench, table or robotic workstation. Note that Z height
with tube is 148mm (tube cap and rubber feet not included).
2.
Since Controller Cable is 6 feet long, Controller and computer can be placed at a distance
from the Motor Unit.
3.
Connect Power Cord from Power Supply to an outlet.
4.
Connect Power Cable from Power Supply to Controller.
Warning: Do not plug Controller in while power is on. Ensure that the Power Switch is in the off
position (“0” is down). Always have Controller plugged in before powering up.
5.
Connect Controller Cable from the Motor Unit to the Controller.
6.
Connect the USB Cable from the Controller to the computer.
7.
Place one or two VP 830SV-50CB SpinVessel® tubes into the Spin Cups. Ensure that the
SpinVessel® is seated securely within the Spin Cups.
Power Cord
Controller
Cable
Controller
Motor Unit
Power
Supply
Power
Cable
USB
Drive
Spin
Cups
USB
Cable
Parts of the System:
