www.vanco1.com
800-626-6445
7
CONNECT AND OPERATE
1. Connect HDMI cable from a source into the HDMI IN port of the TRANSMITTER
2. OPTIONAL: Connect the provided IR BLASTER into the IR OUT port of the TRANSMITTER
3. OPTIONAL: Connect HDMI Cable to the HDMI OUT port to loop-out to a local display such as a control
room display
4. Connect an HDMI cable from the HDMI OUT port of the RECEIVER to a display or sink device
5. OPTIONAL: Connect the provided IR RECEIVER into the IR IN port of the RECEIVER
6. Connect both power supplies to the TRANSMITTER and RECEIVER using the provided power supplies,
TRANSMITTER first, followed by RECEIVER
7. Using the manual toggle buttons on the units or the provided IR remote control, select any available
channel; the TRANSMITTER and RECEIVER MUST be on the same channel (if using multiple kits, set each
kit to different channels to avoid signal interference)
NOTE: If there is no signal on startup, press the RESET button on the TX and/or RX.
NOTE: Transmission distance may differ based on certain environmental factors such as other wireless signals
that can interfere with transmission. Solid core walls, brick, or glass can significantly shorten the range at
higher resolutions.
