Page 3 of 4
H520IN
VANCE & HINES SYSTEM INSTALLATION
1
. Install mounting bracket (1275-P) using supplied M10 bolts (A949HW). (Do not fully
tighten at this time).
2
. Install exhaust using stock exhaust port nuts. (Do not fully tighten at this time).
3
. Fasten exhaust to mounting bracket using the two supplied 1/4-20 screws (A304HW).
4
. Tighten cylinder exhaust port nuts evenly.
5
. Tighten muffler mounting screws.
6
. Tighten mounting bracket bolts.
EXHAUST CARE (BLACK)
1
. When installing a new set of black pipes, make sure your hands are clean and free
from oil. After installation, thoroughly clean pipes with warm soapy water and a soft
cloth. Dry with a clean towel to remove any residue before starting the motorcycle. Do
NOT use anything abrasive to clean pipes.
2
. Avoid long periods of idling as this can cause discoloration.
3
. Intake leaks can cause the engine to run lean and overheat, this could lead to
discoloration.
4
. Make sure there are no exhaust leaks at the junction of the exhaust pipes and the
cylinder head. We recommend replacing gaskets if they are worn.