Vanair 050518, Operations Manual & Parts List

Page: 6 / 210

TABLE OF CONTENTS AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - IV 090012-OP_r0
SECTION 2: DESCRIPTION (CONTINUED)
2.6.14 ENGINE CONTROL (ON/OFF/START) SWITCH.................................................................................................32
2.6.15 HIGH TEMPERATURE INDICATOR LAMP..........................................................................................................32
2.6.16 LOW OIL PRESSURE INDICATOR LAMP...........................................................................................................32
2.6.17 PREHEAT/START CONDITION INDICATOR LAMP ............................................................................................32
2.6.18 FUEL GAUGE/HOUR METER .............................................................................................................................32
SECTION 3: SPECIFICATIONS......................................... 33
TABLE 3A: WELDER, GENERATOR, AND ENGINE SPECIFICATIONS ............................................... 33
TABLE 3B: SPECIFICATIONS — AIR COMPRESSOR.......................................................................... 33
TABLE 3C: SPECIFICATIONS — UNIT WEIGHT AND DIMENSIONS .................................................. 34
TABLE 3D: BOLT AND TORQUE SPECIFICATIONS ............................................................................ 34
TABLE 3E: VARIOUS FUNCTION FACTORY SETTING RANGES ........................................................ 35
TABLE 3F: GENUINE VANGUARD™ OIL CHARACTERISTICS ........................................................... 35
TABLE 3G: MACHINE PACKAGE DIMENSIONS ................................................................................... 35
SECTION 4: INSTALLATION ............................................ 37
4.1 MACHINE PACKAGE RECEIPT/INSPECTION ............................................................................ 37
4.2 MACHINE PACKAGE PREP ......................................................................................................... 37
4.3 SERVICE BODY PREP ................................................................................................................. 37
4.4 MACHINE PACKAGE MOUNTING ............................................................................................... 39
4.5 INSTALLATION AND DIMENSIONS DIAGRAM (PART 1 OF 2) ................................................... 42
4.6 INSTALLATION AND DIMENSIONS DIAGRAM (PART 2 OF 2) ................................................... 43
SECTION 5: OPERATION ................................................. 45
5.1 GENERAL INFORMATION ............................................................................................................... 45
5.2 ENGINE START-UP AND SHUTDOWN PROCEDURE ............................................................... 46
5.2.1 ENGINE START-UP.............................................................................................................................................46
5.2.2 ENGINE SHUTDOWN..........................................................................................................................................47
5.3 ENGINE THROTTLE CONTROL FUNCTIONS............................................................................. 48
5.4 OPERATING THE WELDER ......................................................................................................... 48
5.4.1 WELDER OPERATING PROCEDURE ................................................................................................................49
5.4.1.1 CC (CONSTANT CURRENT) MODE ........................................................................ 49
5.4.1.2 CV (CONSTANT VOLTAGE) MODE - USING A VOLTAGE
SENSING SUITCASE FEEDER.............................................................................. 51
Continued on next page...