vM MP470 MEDIA PLAYER
4
Controls
Precautions
Connections
Maintenance and advice
Technical Specifications
ONLY connect the player to a (professionally installed) wall socket with earth or ground and the
corresponding voltage setting, as indicated on the back of the MP470. Any faulty connection will
invalidate the warranty.
If it is necessary to replace the fuses, use only Slow fuse(s) with the exact same value. The fuse
holders are positioned inside the Media Player and should only be replaced by an authorized Van
Medevoort Service Center. There are no user serviceable parts inside.
The correct order for ON/OFF switching of the various products is as follows:
On: always first the source, then the pre-amplifier, followed by the power amplifier.
Off: always first the power amplifier, then the pre-amplifier, followed by the source.
To prevent damage to your loudspeakers it is advisable, both at switching ON and OFF to turn the
volume control fully to the left. Fully anti-clockwise sets the volume at its lowest level. The same
applies when changing sources.
Place the player on a location with enough free space around, above and rear for ventilation to
regulate / reduce temperature.
Make sure that there is enough space in front of the transport in order to change
CD’s, DVD’s
and
Blu-r
ay’s safely.
Do not put any magnetic devices near or on top of the player, e.g. magnetic media. This can cause
irreparable damage to such devices.
If you experience any problems, always contact your nearest authorized Van Medevoort Service
Center.
Attention:
Visit our website for updated manuals, documents and further information.
www.vanmedevoortaudio.nl/mp470-docs.html
Van Medevoort Audio is not responsible for the quality and proper working of third party software.
