Installation
2637_en_D
PHOENIX CONTACT
2-9
5.
PCI card installation can be in slot 1 (see below), slot 0 (see “For PCI slot 0:” on
–
For PCI slot 1:
a)
Remove the four Phillips-head screws, 1, securing the left side panel, 2, and
remove the panel.
Figure 2-7
Side panel and bracket removal
b)
Remove the retaining screw and washer, 3, securing the bracket, 4. Remove the
bracket from the bracket frame, 5.
c)
Line up the card’s connectors with the PCI slot connector, 6. Carefully push the
card into the connector. After it is fully inserted in the connector, the card bracket
should be aligned with the bracket frame.
d)
Insert the retaining screw and washer, 3, previously removed and tighten to secure
the card.
e)
Re-install the left side panel, 2, using the four Phillips-head screws previously
When installing two cards of the same type, drivers often assign higher priority to the card
in the lower slot number.
2
1
1
3
4
5
6
PCI Slot 1
