3
1.2 Getting Started
---
For tractor with trailer:
turn on the integrated display and trailer ID box, register trailer
into integrated display (see 4.1 in this manual) and set the baseline pressure for each axle.
1.2.1 Set the Baseline Pressure of Tractor
The baseline pressure has been set in the factory at 6Bar (87PSI) for all wheel positions.
We recommend that you set the baseline pressure at the same pressure as standard cold
inflation pressure recommended by tire manufacturer.
1.2.1
.1 Inflate all tires’ pressures to their standard cold inflation pressure.
1.2.1
.2 Find the set key on the back of display. Press the set key briefly to check the
baseline pressure set by manufacturer (6Bar/87PSI).
1.2.1
.3 Press the SET KEY for 4 seconds, you will hear sound “beep”, all backlights will be
on and the screens will show “000”. This means you succeed in deleting the default
baseline pressure.
1.2.1
.4 The system will exit setting mode automatically after receiving signal from all
transmitters.
1.2.1
.5 The display will refresh the tire data after receiving signal. The first pressure value
received will be saved as new baseline pressure automatically.
After the display has received all transmitters’ pressure, then you can press the SET
KEY of display briefly to look up all tires’ baseline pressure.
---
For bus / straight truck / OTR:
turn on the integrated display and set the baseline
pressure for each axle (Just the same as tractor).
--- The screen will remain “000” until the data from its transmitter is received. After data
from all transmitters is received the display will be in the state shown until an alert or
warning condition is detected.
Set Key