Valor Retrofire RF24XBN, Installation And Owner'S Manual

Page: 8 / 30

8
OWNER’S
INFORMATION
Owner’s Information
Remote Control Operation
Your fi replace remote control helps you get the comfort, convenience and aesthetics
you want from your gas fi replace. The remote controls your fi replace in different
ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings
of time, temperature and automatic ON/OFF can only be programmed when the
function display is fl ashing . Be patient when programming as it can take a few
seconds to set.
Setting the time
The fi rst thing to do is to set the time.
1. With your thumb, hold down both the AUTO and TIMER buttons until F fl ashes.
Let go.
2. Note the digital clock on the bottom right hand corner. The ▲ button sets the
hour; the ▼ button sets the minutes. Set the time.
Note: You must start setting the time while the F is fl ashing. If it stops fl ashing,
go back to 1.
3. The display shows °C/24-hour or °F/12-hour. To change the temperature/hour
display, press on the AUTO button while the display fl ashes.
4. Let go and wait until the fl ashing stops. The remote shows the time you set. It
also shows the current temperature.
Servicing
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance’s serial number can also be
quoted. This number is on the rating plate, which is
located under the burner.
The replacement parts are shown at the end of this
manual. Please always quote the part number and
description when requesting spare parts.
Vent Safety Switch
This appliance is equipped with a vent safety switch
which, when activated, will turn off the burner and
pilot if the vent is blocked, disconnected, or if there is
excessive down draught.
If the safety switch is activated, wait for it to cool off
before trying to light the appliance again. The safety
switch will cool off and reset itself automatically after
25 to 30 minutes.
In the event that the safety switch is activated
again, contact a quali
fi ed service technician for
inspection.
Should the safety switch require replacement, only
use parts supplied by Miles Industries.