2
Fixing
screws
Burner
fixing nuts
Fixing screws
underside of
brackets
Conversion Procedure
1. If the fi replace is already installed, remove window
cover with barrier screen, window, and fuel bed.
2. Disconnect the gas inlet pipe from the inlet elbow
fi tting on the valve.
3. Remove the rear log support (4 screws).
4. Remove the burner module (10 screws). If the unit
has been burned previously, it may be necessary
to pry the burner module gasket as they tend to
adhere when removed the fi rst time.
5. Disconnect the burner elbow injector from the pipe,
using a 11/16” (17 mm) wrench.
6. Remove the 6 screws (2 underside of bracket)
securing the burner brackets to the burner tray.
7. Detach the two burner support
brackets from the burner by
removing two nuts, using a
5/16” (8 mm) wrench.
8. Accessing the pilot assembly
from the underside of the
module, disconnect the pilot
pipe, using a 7/16” (11 mm)
wrench.
9. Remove the pilot injector. Replace with the
appropriate gas injector.
10. Remove and replace the
minimum rate by-pass screw
from the valve with the
appropriately labelled by-pass
screw—see
Specifi cations
table on page 1. The screw
has a rubber o-ring holding it
into the valve body and may
require prying out or removing
the screw with needle nose
pliers.
Note - The pilot
injector should be
slipped onto the
end of the pipe
from the side. The
pilot pipe, with
injector attached,
should be inserted
into the assembly.
minimum rate by-pass
screw location
