Valor PORTRAIT 530INI, Installation & Owner'S Manual

Page: 8 / 46

8
ON
OFF
Wall Switch
(optional)
Manual On/Off Switch
Thermostatic Remote
Control
Servicing Your Fireplace
If your appliance require any attention, contact your
supplier quoting the model number. It will be helpful if
the appliance serial number can also be quoted. This is
on the rating plate located under the
fi rebox. The repair
parts are shown in the separate repair parts lea fl et.
Please always quote part number and description when
requesting spare parts.
Operating Your Fireplace
There are three ways to control your fi replace.
1. Thermostatic Remote Control;
2. Manual On/Off Switch;
3. Wall Switch (optional) .
The Thermostatic Remote Control can be programmed
to function automatically—see pages 10–14.
The manual On/Off switch must be ON for the
fi replace
to function. It can be used to shut off the fi replace in
case of emergency—see above.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the
fl ame height—see
1265WSK—Wall Switch Kit.
NOTE: The remote control in the AUTO mode will
override the wall switch.
Owner’s Information
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT!
Let the
fi replace cool fi rst before touching it.
!
Replacing Batteries
Low battery signal: see page 14.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —
see instructions on
next page.
The appliance uses four 1.5 V AA
alkaline batteries for
its remote control receiver and one 9 V alkaline battery
for its handset. The batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
:
1. The receiver is located to the left of the valve and it
is retained to the fi rebox by a
Velcro
tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace batteries with 4 AA
alkaline batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so
it attaches to the
Velcro
tab.
Locating Lighting, Operation and Rating
Information Plate
The Lighting, Operation and Rating information is
located on a plate under the
fi rebox.
To access the plate, remove any fret or access panel
and grab the plate and slide it out to read it. There is
important information on both sides of the plate.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the fi replace cool fi rst before touching it.
!
OWNER’S
INFORMATION